In this lab we will learn how to configure rip routing on cisco routers. For demonstration we have taken total four routers and six networks.

rip routing	lab	for ccna students	packet tracer
rip routing protocol	configuration	ccna batch	software
rip routing packet tracer	lab	networking students	simple steps
cisco packet tracer rip routing	lab	cisco /ccna	certifications lab
rip routing information protocol	lab	ccna training	satish tiwary
rip routing table	important	to understand routing
cisco rip routing	is simple to c onfigure
show rip routing table	#show ip route
rip routing cisco packet tracer	in simple steps	lab	by satish tiwary
which command displays rip routing updates	#show ip route	#show ip protocol
rip routing commands	mentioned in article	step wise	everything
rip routing configuration		0–10
what is rip routing

In the above topology diagram you can clearly see the total 6 networks and 4 routers and 2 pc.

Step:1 Assign ip address on ecah routers.

Here i assume you guys already know how to assign ip address on routers. if you dont know you can see my post on this topic.

Step2: assign ip address and gateway ip on PC too.

Step3: Start configuring RIP Routing on each router.

I am going to start from left to right.

RIPv2 Configuration on Router0:

• Router(config)#router rip
• Router(config-router)#version 2
• Router(config-router)#net 10.0.0.0
• Router(config-router)#net 20.0.0.0
• Router(config-router)#exit

RIPv2 Configuration on Router1:

• Router(config-if)#exit
• Router(config)#rout rip
• Router(config-router)#ver 2
• Router(config-router)#net 20.0.0.0
• Router(config-router)#net 30.0.0.0
• Router(config-router)#exit

RIPv2 configuration on Router2

• Router(config)#rout rip
• Router(config-router)#ver 2
• Router(config-router)#net 30.0.0.0
• Router(config-router)#net 40.0.0.0
• Router(config-router)#exit

RIPv2 configuration on Router3

• Router(config)#rout rip
• Router(config-router)#ver 2
• Router(config-router)#net 40.0.0.0
• Router(config-router)#net 50.0.0.0
• Router(config-router)#exit