Posts Tagged ‘static routing configuration’

Static routing configuration Lab using two Routers and Having three Networks.


We are going to configure static route between router R1 and R2 in this lab with the help of cisco packet tracer.

In static routing Configuration we have to tell the Routers about Indirectly Connected Networks. Although static routing configuration is so complex when network is too big or number of routers are so much.

It is practically not feasible to implement static routing in big companies where there are so many routers. In that case you can use Dynamic Routing like RIP Routing,EIGRP and OSPF.

 

(more…)

Learn how to configure static routing when your router is connected with each other using serial port.Here to make you learn static routing configuration lab easily i have taken a little complex example and configured them step wise.If you are preparing for ccna certification exam this lab will help you to understand and configure static routing.

You can Also Read:

How to configure EIGRP Authentication on cisco routers
static routing configuartion on cisco router using serial port.
How to configure loopback interfaces on cisco router
static routing configuration using 3 routers

 

static routing using serial port (more…)

Learn how to configure static routing using serial port on cisco routers.This is a basic Lab to show you how to configure static routing on cisco router using serial interfaces like se0/0/0 or se0/0/1.This is little bit different from  static routing done using fast ethernet port, because now you have to assign clock rate on on of it interface which will be DCE.

You can Also Read:

static routing configuration using 3 routers
How to configure EIGRP Authentication on cisco routers
vpn configuration lab using routers in cisco packet tracer
How to configure loopback interfaces on cisco router

(more…)