Posts Tagged ‘packet tracer lab ccna’

This is a static routing lab in which we will learn how to configure static routing for a network having three routers inside packet tracer.Here in this  Lab there are  total four network 1.0.0.0/8, 2.0.0.0/8,3.0.0.0/8 and 4.0.0.0/8 and three routers.Using cisco packet tracer i have shown static routing configuration using an example lab.So i even if you are new to ccna or networking you can easily learn by reading this article.This article will help you to easily learn static routing configuration.I have designed the topology diagram using cisco packet tracer which will helps you to understand the Lab.I have also assigned the ip address above each devices and interfaces which will guide you throughout the lab.

You can Also Read:

static routing configuration using 3 routers
vpn configuration lab using routers in cisco packet tracer
How to configure loopback interfaces on cisco router
static routing configuartion on cisco router using serial port.
How to configure EIGRP Authentication on cisco routers

static routing lab

To make PC0 communicate with PC1 we must configure route,because they are in different network and is connected via routers. (more…)

Advertisements