Archive for April, 2018

redistribution configuration lab between two eigrp autonomous system using cisco packet tracer

Posted: 22 Apr 2018 in CCNA
Tags: ,
1

This article is all about redistribution configuration lab between two eigrp autonomous system . Here in this lab we will configure  EIGRP  having different autonomous number. To show Multiple EIGRP AS configuration on same router i am using cisco packet tracer. You can see EIGRP neighbors with different AS numbers in this lab and you will learn how to configure it to communicate them.In below topology diagram you can see EIGRP Topology having different Autonomous Value. There are total three routers R1, R2 and R3 R1 is in As 1 while R3 in AS 2. But R2 is in both AS.Now read carefully how i am going to configure it.

(more…)

Advertisements

cisco packet tracer lab:configuring rip routing lab using two routers

Posted: 22 Apr 2018 in CCNA
Tags: , , ,
0

This is a RIP Routing Configuration Lab using two Routers. In this article i have shown how to configure rip routing using cisco packet tracer. This is an example lab showing rip routing and it’s configuration having two routers and three network as mentioned in below topology diagram. I have tried my best to make it easy for you to learn rip routing in just few simple steps. I have also tried my best to explain the rip routing code and there usage and why they are necessary.Apart from RIP routing configuration I have also included RIP routing Troubleshooting command which will helps you to troubleshoot your network problem where RIP Routing is configured.

http://www.youtube.com/watch?v=J7QH_d6ZM-E

(more…)

cisco packet tracer lab:configuring static routing using two routers

Posted: 22 Apr 2018 in CCNA
Tags: ,
0

This lab is all about static routing configuration. Using cisco packet tracer here i will explain static routing configuration in simplest way and try to explain you the static routing configuration codes. So you can   easily understand static routing configuration using this example lab having two routers and total three network. I have used cisco packet tracer software to show this static routing lab. In this article i will also show you how to assign ip address on router interfaces and how to setup ip address and gateway ip on PC. (more…)

RHEL7 Online Interview Self Practice PART-1

Posted: 16 Apr 2018 in RHEL7
Tags: ,
0